If you’re playing around with Sensirion SPS30 and ESP32, I just uploaded on Thingiverse a case I designed for this. https://www.thingiverse.com/thing:5737463
I recommend printing the top part in black, as the led of the esp32 can be a bit too shiny. I know have 2 of these in the home.
Hello, To achieve good results, you must follow the design rules imposed by SENSIRION
So the design is OK, just need to flip the SPS30 so the green side is facing down. Or just leave the green side on the top but put the whole case on it’s side so outlet flow is below inlet flow. Correct ?