Hey everyone,
I’m using a P2 sensor for my garage door and have it connected to Apple Homekit. Works fine there and worked for a little while when I first set up Home Assistant.
However it has been unresponsive in HA for a few days (cannot be found) and I now tried removing and adding it again.
That did not work. I can start pairing mode in Homekit, but entering the code in HA will only end up in HA endlessly showing Device being added.
Did let this run for 15 mins, without anything. Then I removed it from Homekit entirely, reset it, added it again in Homekit, only to end up the same in HA.
So again, it works in Homekit, but not HA.
As this is my first time setting up HA, it’s been quite frustrating…
Anyone have any ideas?