Hello everyone,
I’m a bit late with my post, but I believe I’ve found a solution to this problem. At least, it worked for me.
I have several Aqara devices in use, and recently I’ve been facing an issue where the devices regularly disconnected. I had tried pretty much every troubleshooting step I could think of.
Eventually, I discovered that Aqara devices can sometimes have significant issues with meshing. In my case, this caused massive problems because the Aqara buttons and sensors kept losing their connection while meshing.
I read that Aqara sensors and switches have a known issue where they don’t re-mesh properly. They seem to remember the point they were initially connected to and stick to it permanently.
My solution was to connect all devices either directly to the mesh controller or to a device nearby. You can see how to do this in the screenshot.
Since then, I haven’t had any problems. I hope this helps some of you as well.
Best regards,
Garfieldtt