How to pick a port for wyoming protocol?

[overexert7359 (Overexerted Tinkerer)]

Update, just for reference:
I looked through this thread, at this specific comment:

How to manually install Piper

Yes, it’s possible. The easier way is to use official docker image and you can run it on another host if you want, just specify the right IP address and ports when you will configure the integrations. You can use this working solution based on docker compose or run the containers manually :

1. I started the docker containers on a server and noted their IP addresses/ports
2. I enabled the wyoming integration. I used the ip/host of the server. For port I used one of the ports, I think it was for piper. This set it halfways up.
3. Inside wyoming, there is a button to add another (server? connection?) at the bottom. This allowed me to enter the host again (or another host) and port. It auto detected this as the missing portion and left me with whisper/piper working.

It wasn’t painful, but it’s not exactly intuitive. If you’re installing two services, why do you have to link one to set the integration up, then have to repeat the process once inside? It’s…function, I’ll give it that.

TL;DR;

1. Run Whisper/Piper
2. Install Wyoming, specify a host/port for one of the services
3. Inside the integration, add a connection to the other host/port