Installation process loop stuck


#1

Hi, I’m new here and I have a problem in the installation.
I have a Raspberry Pi 3 plus. I can see the hassio in my router, but when I try to access it, the page says that the site cant be reached.
I connect the raspberry to a monitor and the process is looping on:

IPv6: ADDRCONF (NETDEV_UP): wlan0: link is not ready
BRCMFMAC: power management disabled

I tried various SD cards and no luck, always is stuck in the same place.
Does anyone had this issue and was able to solve it?
Any help?

Thanks


#2

Are you trying to connect via wifi or wired connection?

Are you installing Hass.io or via another install method?


#3

I’m having the same issue. Brand new RPi 3+ tried both 32 and 64bit images. No luck


#4

I just tried to install the HASS.io. (following this procedue) The connection is by wire and it is connected to the modem where is my PC.
I can see in my modem the IP address assigned to “hassio” but the when I tried to access it by the method of http://address:8123 or http://hassio.local:8123 the browser said that is not available…


#5

I also have a brand new Raspberry 3+, I tried 32 and 64 bits, also different SD cards… No luck!


#6

Are you giving it time to install? ~20 min


#7

Or longer… it’s easy to be impatient!


#8

I left mine a whole night, no changes…


#9

Yes … I leave it alone for a long time and the message is repeated again and again …