Kauf smart bulb stuck in testing mode

1

Hi - I have 4 Kauf A19 smart bulbs.

3 are working fine, but 1 is stuck in some sort of test mode and just keeps flashing red, green, blue and white.

I’ve powered it off and on (pulling power and also via wifi from HA and via the device itself) with no change. Along with modifying other settings.

These all have the same reported firmware and hardware:

Firmware: 2022.6.1 (Jun 19 2022, 19:45:13)
Hardware: 1.851(f)

Is there some command I can send to get it out of this test mode?

I’ve searched around but have not found anything so far.

2

Ok, found the troubleshooting page on github, left the light on for 10 minutes and now it’s fine.