PST02B Reset motion detection

Hi,

would anyone have the above motion detector working correctly? Currently my sensor shows as ‘motion detected’ and no matter what I choose in the configuration, this doesn’t appear to reset. I wonder if anyone can share their setup, if they have it working.

These are the current settings I have, and they appear to have been updated, when the device was awake:

Any help gratefully received,
Tony

I don’t, but go into device configuration and see if their are disabled entities. If there are enable them and restart HA. One of these may work for you.

Thanks Pete, found a suspect disabled entry, which seems to be working, as highlighted below, incase anyone else sees the same issue:

image

Once enabled, the newly enabled parameter can then be used for conditions.

Thanks
Tony

1 Like