Why is this SOOOOOO slow? Where do I check? Also what about the “scan_interval” of 10 seconds I keep reading about that I cannot find? either way with a two to three minute delay before the motion even appears on my home assistant dashboard, It seems like there’s something majorly wrong…?
did you figure this out? I am having the same problem. notification are delayed 10-15 minutes.
No. Useless crap. I’ll switch the hardware when I get around to it…
I thought there was an MQTT thread somewhere around here for Ring but I believe that has to do with grabbing the video off of the unit, rather than the motion detection. Bummer. If I can’t find anything on this forum I’ll have to throw it out and start with new hardware. Anybody have a better suggestion for the hardware?
@dhellerstedt I made a video showing the solution here. I am beyond thrilled.