I’ve got several Shelly 2.5 devices flashed with ESPHome, but for some reason one of them is having an issue reading the ADE7953 Power Sensor. Here is the error message I am receiving. Any ideas?
[07:44:02][C][i2c:028]: I2C Bus:
[07:44:02][C][i2c:029]: SDA Pin: GPIO12
[07:44:02][C][i2c:030]: SCL Pin: GPIO14
[07:44:02][C][i2c:031]: Frequency: 50000 Hz
[07:44:02][I][i2c:033]: Scanning i2c bus for active devices…
[07:44:02][I][i2c:049]: Found no i2c devices!
[07:44:59][W][i2c:070]: Received NACK on transmit of address 0x38
[07:44:59][W][i2c:070]: Received NACK on transmit of address 0x38
[07:44:59][W][i2c:070]: Received NACK on transmit of address 0x38
[07:44:59][W][i2c:070]: Received NACK on transmit of address 0x38
[07:44:59][W][i2c:070]: Received NACK on transmit of address 0x38
[07:45:29][W][i2c:070]: Received NACK on transmit of address 0x38
[07:45:29][W][i2c:070]: Received NACK on transmit of address 0x38
[07:45:29][W][i2c:070]: Received NACK on transmit of address 0x38
[07:45:29][W][i2c:070]: Received NACK on transmit of address 0x38
[07:45:29][W][i2c:070]: Received NACK on transmit of address 0x38
[07:45:38][D][adc:056]: ‘temp_analog_reading’: Got voltage=0.32V
[07:45:38][D][sensor:092]: ‘temp_analog_reading’: Sending state 0.32129 V with 2 decimals of accuracy