Since my garage is too far for my Zigbee network, I decided to buy the ZB-GW03 hub to extend the radius. The hub just arrived and I set it up (and upsated it to firmware 1.1.6) as per the instructions with the ewelink app and it’s recognized by HA with the Tasmota integration. But what after that? It don’t seem to have any IP address, no way to configure it. From the Amazon page (Joselin Smart Home ZigBee 3.0 Hub gateway cablato RJ45 Bridge Ethernet TASMOTA firmware MQTT per MQTT Home Assistant Zigbee2MQTT : Amazon.it: Informatica) it’s listed as Tasmota, so I guess it has already the Tasmota firmware loaded, but it should have a configuration address to at least set up MQTT. I’m I correct or I’m missing something?