ZBT-2 Died. Now what?

Configuration Zigbee
1

Just got my ZBT-2, which is replacong a SkyConnect. Plugged it in, HA (container) found it, installed Zigbee firmware and migrated my Zigbee network. So far so good.

Shut down HA and my machine to move a cable. When I brought it back up, the ZBT-2 didn’t start, and the LED doesn’t light up. The integration says that the device is not plugged in.

Tried it on another computer, but it doesn’t show up. The device is apparently dead.

So now what? Is there any way to restore my Zigbee network to the SkyConnect?

Thanks,

John

2

If you are certain it is dead, you could open a ticket I guess? https://support.nabucasa.com/hc/en-us/requests/new

3

Thanks but it’s back. Plugged it into a Windows machine and went to the firmware update site, the machine say it. Plugged it back into the HA machine, and it came up. Must have been operator error of some sort. I’ll keep an eye on it, just in case there is a hardware issue lurking.

4

Maybe the firmware update is a ‘two boot’ process like a lot of things I am seeing in recent posts in these forums?

5

No, it was likely something I did. The LED going off surprised me, but the docs say the light is off during normal operation.It’s working fine now.