Without any config change (the only change is updating Home Assistant) - time to time my automation get stuck half way thru. I cannot run them again. I need to restart HA to get them running.
From the interface (I am not allowed to post pictures directly here)
You would think that I got some old dead devices in there - but nope, just went thru them all and nothing broken. I can also access all devices (and their entites).
How can I prevent this from happening? Any change to HA automation that got deployed during the last months that can have created this issue for me?
Late comment, maybe too late, but I just encountered the issue yesterday. (I am still trying to figure this and I could only half confirm)
My sequence seems to get stuck, when the “smart bulb” has no power. When I push the light switch; one light is already off (without power to the zigbee).
I did spend a few hours fiddling around with it, before I noticed what might cause it.
I just do the first experiments, so I assume it is due to clumsy setup.