Ecodim 1 channel remote (ED-10010) for deCONZ. Below links to gist for 1, 2 and 4 channel versions. Based on @daniel.baer’s icasa Pulse remote.
Ecodim remotes are somehow upside down where the on button is place left with the led faced upwards. For my automation / blueprint I “turn them around”.
@Sandje i actually now see you already tried the adjusted version my neighbor @PaulAntonDeen made based on my earlier work. Paul optimized these for zha, is that not working for you?
Thanks for your comment @RT1080.
I do have @PaulAntonDeen post, but your’s is a bit more elaborate. with Paul’s I can only operate lamps, but I also want scenes, etc. Even the long pressing option is not visible in that blueprint.
I think I can add that, because I followed your tip to look at the event listener.
But finaly, I want your blueprint, but then for a zha
Yes, trick is indeed to listen for all events and include these in the blueprint. Good luck with making the changes, once done feel free to circle back.
Hello all,
Recently I purchased the ED-10010 and added it through ZHA. The switch is detected and configurated. When I press buttons I can see them in my logfile (On event was fired, Off event was fired and also long hold etc.) So far so good. However, when I want to make an automation I dont get to see the “on or off” button to actually switch something on or off. Only Battery status or “button press” are available.Any thoughts on this? Your help is appreciated !
Yes triggering automation, I have several zigbee receivers to control lights. However i’m not able to use the “on” and “off” buttons from the ED10010.
For automation the only available options I have are
Do something when…
Device offline
Pantry schakelaar Identify has been pressed
Pantry schakelaar Battery battery level change
when I press the buttons of the ED10010 I can the following in my screen
Pantry schakelaar Off event was fired
10:48:45 - Now
Pantry schakelaar On event was fired
10:45:06 - 4 minutes ago
It seems the buttons I need are detected but not visible to use in automations…
Ok. But there are no buttons in your device - that is normal. The blueprint should give you the option to define an action on an event fired. But perhaps we are talking cross purpose. See below screen when setting up automation with the blueprint: