This is the internal Docker IP, not the actual IP on your network.
# Network
HassOS uses NetworkManager to control the host network.
## Configure network
Only a manual configuration using NetworkManager connection files is supported. Without a configuration file, the device will use DHCP by default. These network connection files can be placed on a USB drive and imported to the host as described in [Configuration][configuration-usb].
## Configuration examples
You can read the [NetworkManager manual][nm-manual] or find many configuration examples across the internet. Keep in mind that the system is read-only. If you don't want the IP address to change on every boot, you should modify the UUID property to a generic [UUID4][uuid]. Inside the `\CONFIG\network\` directory on the USB drive or SD card, create a file called `my-network` and add the appropriate contents below:
### Default
A preinstalled connection profile is provided by default:
```ini
[connection]
id=my-network
uuid=f62bf7c2-e565-49ff-bbfc-a4cf791e6add
show original
The over-simplistic CLI is due to the OS that your install method runs on. Its not a full linux distribution like you may be used to. Its has what it needs to run HomeAssistant and that is about it. this is a plus from a maintenance/security perspective but can throw off some users who try to use 'traditional' linux commands.
This may also be of interest.
Network configuration | Home Assistant Developer Docs
3 Likes