Hello everyone, we all know that when the esp32 device has no network configured or is not connected to the network, it will enter AP mode so that users can configure the WIFI it can connect to; but when the esp32 is already connected to wifi, is there any way to make the esp32 enter AP mode again? …

Looks like you can do both AP and station mode simultaneously. [image] WiFi Component Instructions for setting up the WiFi configuration for your ESP node in ESPHome.

This was discussed in a recent thread; [image] Enable access point mode on demand? ESPHome Is there a way at present to force an ESPHome device to switch to access point mode? My setup is that I hard code wifi networks and IP addresses to all my devices to maximize relia…

How to manually put esp32 into AP mode

Configuration

Ellcon March 13, 2025, 3:02am 3

This was discussed in a recent thread;