First post here and my first expericence with HA.
I have HAOS installation with Sonoff Plus zigbee3 with mosquitto and zigbee2mqtt.
I did have some start erros in log but followed tutorials and now startup is error free.
Received soem devices today and went to pair. Phillips hue dimmer switch V2. I hit the reset button and the amber light light flashes to say in pair mode, I then when to zigbee2mqtt and the timer starts. At this point I am not seeing my device.
Any pointers would be appreciated. Any guidance on validating the setup would also be appreciated.
So it seems my issue maybe more specific than just hue. Today i received a shelly plug. From what i have read thia should be picked up in HA. I tried using the shelly app and added the device but this is always saying pending connection but atleats it can find it.
Are there any good sources for checking config. I have read that wifi channels van cause issue but i am sure i have channel set that would not cause issue.
@wmaker had some issues aswell with my hue motion sensor. After some digging seems that a switch to channel 25 cures this. Have not tried the dimmer switch yet, was embarking upon some Aqara and thred but seems I need a different dongle as I have the sonoff P and should of got Sonoff E for zigbee and thread…
Well, the E dongle would not get you zigbee and thread at the same time - well, you could if you absolutely want to, but the dongle E would not work perfectly as you would have expected. You likely would want to pick one.