This morning I upgraded HA to 0.47.1. Now my Lutron configuration, which was working fine previously, isn’t working. Everything comes up in States just as it did before – all lights, automations, presence indicators, shades, etc. – but none of the Lutron devices reflect their current states. For instance, I’m sitting here in the Office and can see that my Desk Lamp is on. Whereas previously the States screen upon opening would show the Desk Lamp’s slider in the ON position, all sliders are now initially in the OFF position. I can move a slider ON and the corresponding device will turn on, but then the slider immediately moves back to OFF even as the device remains turned on. I cannot further operate the device at that point. It stays on regardless of moving its slider.
Configuration | Check Config shows “Valid.”
The only relevant information in the home-assistant.log file is this:
2017-06-21 21:15:52 WARNING (MainThread) [homeassistant.setup] Setup of lutron is taking over 10 seconds.
But it’s always displayed that warning. The only other entry in the log is a netdisco error for the router:
2017-06-21 21:16:22 WARNING (SyncWorker_9) [netdisco.ssdp] Error fetching description at http://192.168.1.1:8200/rootDesc.xml
My configuration is HA running on a Synology NAS in Docker.
I would greatly appreciate advice/assistance.