Upgraded to SSD and now I've no zigbee

Configuration Zigbee
#1

I’ve just (this morning) upgraded my Pi 4 system to a new SSD installed into a Argon One M.2 case and it seemed to be ok. That was until my wife reported that my aqara motion sensor in the kitchen wasn’t working. Then I realised that NONE of my zigbee sensors were on there either.

I use a conbee ii and have tried to move the stick away from the ssd using a 1.5m usb extension but that hasnt made any difference either. Checking the intergration I get this:-
IEEE: 00:21:2e:ff:ff:08:35:31
Nwk: 0x0000
Device Type: Coordinator
LQI: Unknown
RSSI: Unknown
Last Seen: 2022-06-02T11:33:17
Power Source: Mains

I’ve plugged the conbee into the laptop and it seems fine.
Is there anything else I can try??

zigbee
zigbee1158×460 40 KB

#2

Right now we dont even know what you are using for Zigbee, is it zigbee2mqtt? ZHA? in a docker? on another server?
What does the log say? or the controller log (whatever controlls your Zigbee)

#3

Appologies and forgive my ignorance. but also thank you for a reply.
Being new to HA is deffinatly a learning curve and (like many others I suspect) am looking at so many answers sometimes that its hard to know quite where to ask the questions. Also “trying to run before you can walk” doesn’t help.

I’ll move this to somewhere else…

#4

Make sure you use an USB-2 port, and keep the USB extension cable.