Vacuum Interactive Map Card

Yes, cleaning by room will be supported

1 Like

Hi, im trying to install it through HACS, however it keep spinning and never gets installed

I do see the files are there in
\config\www\community\lovelace-xiaomi-vacuum-map-card

Thoughts?

Anything in logs?

While its spinning during the HACS installation. i saw this in the logs

image

I did try the manual install as well according to the doc
i have the error “Custom element doesn’t exist: xiaomi-vacuum-map-card.” as well
its under /www/custom_lovelace/xiaomi_vacuum_map_card

Yes i do see the module under my dashboard resource as well

update: it works now, for some reason i cant make it work with HACS but with the manual install its working.

New (very big) release of the Map Card coming soon!

image

8 Likes

use SERVICE XIAOMI_MIIO.VACUUM_CLEAN_SEGMENT in automation. I can not get a replay of cleaning segments. what to do? thanks in advance to those who helped

Why my point are outside map?

I took these points from camera.xiaomi_cloud_map_extractor

They do not need to be on map, no problem here

There is possible to delete this area on map ?

No, it’s not possible, but you can change fill color for this area to transparent, you will end up with something like this:
image

You can also trim the map to make it look like this:
image

1 Like

So since my last reboot of HA i’m having this 2FA issue again. The card shows:
image
(It’s hard to read, but it says “Two Factor auth required (see logs)”

In the logs it shows:

If I use the link in the logs (only valid for about 1 minute) I get prompted for 2FA. However, after filling that in and the site showing “ok” the card and the logs still show the error. Reloading the integration results in the same error on the card and in the logs, also generating a new 2FA link.

The previous time I had this issue, it was solved by installing another Xiaomi integration through HACS, that used the same token. However, that doesn’t work this time.

I have rebooted several times, did the 2FA link several times. It just doesn’t work.

Any ideas?

This is not a correct thread for this problem, this one is.

Check out these issues: #157, #180

Oh sorry. I thought because someone else mentioned this issue in here, I could too. But I will check out the issues!
Thanks!

@3_14 Hello, Piotr! Could you clarify about Roborock S5/S50 - is it gen1 or a newer one?
My doubts are regarding “saving map” feature: it is turned ON in Mi Home but I have to perform a zone cleaning otherwise a map is shifted every time with respect to my floorplan.

Gen1 has problems with map saving, I have S55 (pic attached)

Is S55 of Gen2 or smith?

As far as I remember it was a second vacuum by Xiaomi, first one with Roborock brand

I think it is mentioned before but I do need to read 822 messages to find.
How can i find coordinates for zone cleaning?

You have to add debug: true in card’s config, draw zone on the card and click start. Zone parameters will be presented in a pop-up (instead of starting a vacuum)