Zigbee - long press triggers

[davinci]

Is there support in ZHA for long press triggers? If not, it should be possible to check after a 500 ms if it is still on. I would assume the device then sends an on and an off signal. In that case this would work for me.
Is that correct?

I don’t have the switches yet, but I am thinking about the automations.

[niro1987 (Niels)]

depends on the device, not zha. What devices are you looking for?

Here is an example: ZHA - IKEA TRADFRI - 2 Button Remote - OnOff and Brightness

[davinci]

Aqara Mini Switch.

[niro1987 (Niels)]

@davinci

Aqara Mini Switch

ZHA - Aqara Wireless Mini Switch

This Blueprint will let you configure an Xiaomi Aqara Wireless Mini Switch paired to the ZHA integration. It supports four commands - single press, double press, long press, and release. [Aqara-Mini-Switch] Note: Apparently the manufacturer made 3 different revisions of this device over the years, each with slightly different capabilities. This Blueprint requires the lumi.remote.b1acn01 model (which I purchased at the Amazon link below). Also, an additional tip: if you select the “Choose” ac…