Add new end devices to router

Hi all,
I have problem with connecting end devices to routers.
Pairing works fine and in the end I can see in the log “Successfully configured device” but after few seconds is there a message “Device left the network”. Sometimes pairing starts again, but with equal result.

When I tried connect end device directly to coordinator, there is no problem and device stay in network. So I hope it’s configuration problem and I’m missing something really obvious, but after few hours I don’t know where to look.

I use docker compose and I have containers for Home Assistant, mqtt broker and zigbee2mqtt

End devices: Tuya WSD500A
Routers: Tuya TS011F_plug_1 and Sonoff ZigBee Mini
Coordinator: Raspberry pi (OS lite 32bit) with SONOFF ZIGBEE 3.0 USB DONGLE E

Regards,
h0nz4gem

Hi,
I have the same issue with the same config on my side;

End devices: Tuya WSD500A
Coordinator: Raspberry pi with SONOFF ZIGBEE 3.0 USB DONGLE E

Happy to hear if someone got this resolved

Hi,
in my case worked:

  1. pairing routers in locations where it would be placed
  2. pairing end device directly to coordinator near to coordinator (I set pairing to all devices in the zigbee2mqtt)
  3. put end device near to router
  4. clicking end device’s button to activate device (not for pairing, only for sending a messages) and checking zigbee2mqtt’s map in my mobile if it works (circle around end device is blicking bold)
  5. repeat for all end device

I hope it is understandable :slightly_smiling_face:

Regards,
H0nz4gem