Aeotec Multisensor and HomeBridge

[nashlib1 (Nashlib)]

Hi,
I have a AIO instance of HA running on my Pi3. And I also have a home-assistant.homebridge plug-in running on the my homebridge instance to expose all HA to HomeKit.

I have an Aeotec Multisenosr. I’m able to see All of the senior reading except Motion on my HA and my HomeKit. Not sure if I need to change anything in the Z-wave configuration.

Regards

[petro]

Check out this thread, might lead you in the right direction.

Aeotec MultiSensor 6 Configuration

I am sorry to seemingly keep beating a horse (he’s not quite dead yet), but I am seriously trying to figure this out. And perhaps because I know it works in both Vera and SmartThings I just cannot get it figured out in HA. When I set up the MultiSensor 6 in HA, I noticed that when motion was detected, it would trigger what I wanted to trigger, however, instead of indicating motion, it simply had a value that changed for the Burglar/Motion. For motion, it would change from 0 to 8 and for tampe…

[nashlib1 (Nashlib)]

Thanks a ton - worked !!!