Aeotec Smart Switch (ZW096) shows as Light and switch

Hi All, new to HA coming from Vera and Hubitat. I have added an Aeotec ZW096 smart switch to my test HA install and it appears to be working ok but I can’t figure out why it shows as both a Switch and a light? I get duplicates of the on, off & toggle commands available, with one controlling the “switch” and one controlling the “light”. The “switch” does turn the switch on and off correctly but the “light” doesn’t do anything to the device itself that I can see? I didn’t see this when the same device was in Vera or Hubitat where it just worked as a plain switch.

O5DMCuHJZp|471x400


lxV9788GEM

Thanks all!

The light entity controls the RGB LED.

https://aeotec.freshdesk.com/helpdesk/attachments/6102433596

Thankyou, for some reason I can’t open the attachment?

If I turn the “light” switch on/off in HA I don’t see any change on the switch LED itself?

Fixed the link, the forum software got a little overzealous trying to render it.

You need to configure the LED for Night Light mode (param 81).

Aha, that makes sense now, thankyou!