Aeotec z-stick gen5 send network information

Configuration Z-Wave
1

I am trying to use the z-stick as primary controller and a ZURC and GE remote as secondary controller. However, I cannot figure out how to copy the network information to the other controllers.

Is there a command that can be send to make the z-stick send network information? I hope to be able to do this without the zensys tool as that requires windows.

Thanks.

2

I can’t remember the exact steps I did to get my Intermatic HA07 to work as a secondary controller, but I do recall that you’ll need to do it from the Open Zwave Control Panel. IIRC, you put the secondary controller into include mode, then include from OZWCP. That’ll make OZWCP copy the network over to the controller.

3

The second controller is just a remote, how should I include it in OZWCP?

4

It somehow worked with “Replication Send”.

1 Like