Blebox problem with the controller to replace the device with new ones


I’m having an issue with the BleBox SwitchBox driver. Everything was working fine until the driver burned out and was replaced with a new one. After reconfiguring it in HomeAssistant, the lighting control switch works, but it still reports an error message. How can I get rid of this message if there is no issue present?

The new driver has been named the same as the previous one, with the same IP address assigned, and the configuration in HomeAssistant proceeded without any issues. I have removed the old driver, and the system detected the new driver, which has been added.

Below is a photo of the message that appears when the light is turned on or off.