Blitzwolf Zigbee Motion sensor via ConBee II How to connect

Hi it is me again
I got Raspberry Pi 4B 8GB and ConBee II connected with no issues.
I got the BlitzWolf BW-IS3 motion sensor and I can not find any info how to connect it without tuya zigbee bridge?
I am starting Phoscon searching for sensors
resetting the sensor by pressing the reset button for 5 seconds it blinks red and nothing is happening?

Additionally it found one on off switch but i do not have any zigbee switches?

I don’t see this device on the supported devices list, so you may be out of luck.

Works in ZHA

What is ZHA?

OK Got it and it works

Hi.

I’m interested in adding some zigbee motion sensors to my setup. This is the only post I could find about the BlitzWolf BW-IS3.

Do you like them? Do they work well? Do they have any issues like delay or a dead time between triggering?

Thanks