Colored automation blocks (negative/positive) to prevent mistakes in setup

After the update there’s a lot of text you need to read to see what it’s doing.
To read it in a sentence makes it a lot easier to understand what your automation does.

However, when you have a few conditions after each other it becomes quite hard to spot mistakes.
See the picture below, which condition is about not detecting motion and which one is about detecting motion? I looked 3 times why it wasn’t working. First there were other problems but now spotted this silly one.

My proposal: make the conditions on binary sensors colored based on positive or negative scenario’s.
I suggest light-green and light-red.