Danfoss Ally shows heating all the time

Hardware
1

Hi. All my Danfoss Ally thermostates are connected via conbee II and zha. They all have the problem that they are show heating all the time and not only when actual und target temperatures are crossing each other.

Is this a config problem?

image
image1626×464 26.2 KB

Firmware is 0x00000108

Thanks!
Robert

1 Like
2

I’m experiencing a similar thing. The Danfoss Ally TRV never goes idle and heating demand remains at 1% even for low target temperature. Unfortunately, I have not yet found a fix for this. I only suspect it might be related to setting the external temperature. It became better for a couple of TRVs after temporarily disabling it but some still did not work well.