Disarming alarms system causing zwave slowness and dead nodes

I have a lot that runs when a door sensor triggers the alarm system. I have a august door lock, 3 Inovelli LED switches, 1 zooz 6 button LED switch that all 4 of them get updated with LED colors and my neo cool siren which beeps to let me know that I need to disarm the alarm.

I wasn’t having any issues until I updated to a 700 Zooz Stick. Not sure what is causing the slowness. My theory is the august lock causing a lot of network noise.

Attached are my logs. Not sure if there is anything anyone can figure out?
https://pastebin.pl/view/03dbe984
https://pastebin.pl/view/2472b0c7

Some most likely reasons:

  1. There is interference from the USB-port (3.0), try using an extension cable to bring the Stick further from the host device.
  2. The firmware of the Stick is not up to date. The 700-series suffer(ed) a lot of performance issues on older firmware. I don’t own a 700-series controller so I’m unsure if everything has been resolved or not.

Thanks for replying, I have an extender it’s about 6 inches but when I had the old stick, it wasn’t an issue. My firmware is also up to date.

I posted the logs as maybe I’m doing to many zwave commands at once. I’m gonna move my unit closer to the devices and see if that helps.