This may be the wrong category (please move if desired), and certainly isn’t the core of this forum, but I’m not quite sure where else to ask this question so hopefully someone has some thoughts!
I have an esp32 controlling a motor with a couple of reed switches to open and close a door using Esphome’s cover - works great! The problem is it’s made using a LM2596 buck converter and a breadboard which is less than idea packaging, so I decided to stretch further and see if I could have a board made to replace the separate converter and breadboard.
If someone has a little bit of time to take a look at this and give me feedback I’d greatly appreciate it - any feedback is welcome! This is my first project, so lots of learning, and likely some stuff that’s not quite right. I’m on both the esphome and home assistant discord too if someone wants to ping me there - @jlambert.
Kicad files: syd_door.zip - Google Drive
Schematic:
Layout:
Thanks for your time!