Fibaro FGMS-001 not sending Motion Canceled

Configuration Z-Wave
1

Hi,

I have two FGMS-001 (EU Z-Plus) sensors connected to Home-Assistant (RPi3 with OpenZWave).

I’ve set them up with the following non default settings:
Motion sensitivity: 8
Cancel motion alarm: 120
Tampering sensitivity: 0
Temperature threshold: 5

I added and excluded several times, I’ve also reset both sensors several times (hold the button until it lights up yellow, the click again and it confirms by blinking red).
One sensor always work not matter how many times I reset, include/exclude etc… but the 2nd one don’t.
No matter what I do, I can’t get it to send motion canceled (ie set Burglar to 0).

I someone can help me figure out what might be wrong.

2

Hi,

Have you managed to find a solution for this? I’m having the same issue.
Every time I exclude/include a fibaro motion sensor another one start behaving like this and never stops.

3

I switched it out for a new, but I’ve seen it a few times after that too, But now it was a very long time since it happened.