Fibaro motion sensor only showing up as one device

I hooked up a fibaro motion sensor, but it’s acting really weird.

One I include it into the network, it shows multiple sensors - most of them look ok and have the right prefix, but there’s also one named binary_sensor.sensor, and the alarm sensors are missing the prefix as well.

However, after I reset Hass, only the binary_sensor.sensor is present, and the other aren’t picked up. Additionally, the Z-Wave card and panel show the node in the `Initializing (Probe)" state, and only a single entity.

What am I missing?

This seems to have resolved itself after a day.

And started happening again :confused: