Hassio-supervisor unable to pull armhf-homeassistant container

[psyko_chewbacca]

I’m getting

18-09-13 02:54:27 INFO (SyncWorker_0) [hassio.docker.interface] Pull image homeassistant/armhf-homeassistant tag landingpage.
18-09-13 02:54:27 ERROR (SyncWorker_0) [hassio.docker.interface] Can’t install homeassistant/armhf-homeassistant:landingpage → 404 Client Error: Not Found (“manifest for homeassistant/armhf-homeassistant:landingpage not found”).
18-09-13 02:54:27 WARNING (MainThread) [hassio.homeassistant] Fails install landingpage, retry after 60sec

over and over again.

I’m trying to install Hass.io on a Cubox-i 4x4 running Armbian 18.04.

What is this “landingpage” tag? Couldn’t this be changed to use the “latest” tag?

[letsoulfly (Bob)]

Perhaps this is the solution…

Hass.io won't update to 0.52.1 - error 404

I’ve got a similar problem while updating to 0.76. Log said, that there is not enough memory. Silly, cause I run my RPi3 Hassbian OS (with Hass.io on the same machine) on USB drive… Solution was expanding my swap partition. If you can SSH, try: sudo nano /etc/dphys-swapfile Then raise the value from 100 to something higher (I did 512). After that run sudo systemctl restart dphys-swapfile greetz Bob

BTW The landing page is just the maintenance page when hassio is updating

[psyko_chewbacca]

Thank but I ended up just install Home Assistant directly. Shame because I wanted to use Addons.

[flamingm0e]

@psyko_chewbacca

Shame because I wanted to use Addons.

install Docker and configure some containers. Add-ons are just docker containers…you can mimic the setup yourself, you just gotta work for it, and you don’t get the menu options

[letsoulfly (Bob)]

It was also frustating for me. Tried to install hassio on Armbian (BananaPi Pro). Dont know why. Till now, I think it was caused by my exotic (OS and HW) configuration…
If you still wanna use hassio and install it by hassio script
curl -sL https://raw.githubusercontent.com/home-assistant/hassio-build/master/install/hassio_install | bash -s -- -m MY_MACHINE
You could use portainer (but not as hassio addon ) to get more infos or control…

[psyko_chewbacca]

That’s what I did at first, specifying “armhf” has my machine type but it still gave me the error mentionned in OP.

[letsoulfly (Bob)]

@psyko_chewbacca

specifying “armhf”

Ah OK, thought that “qemuarm” is the machine type to go…
Did you try expanding your swap?

[psyko_chewbacca]

No, I gave up on this and went for “Vanilla” Home Assistant install in a Python Virtual Environment.

The SBC I have use has 2GB RAM and 1GB swap. Shouldn’t this have been enough already?

[letsoulfly (Bob)]

You’re right…this should be enough.