Home assistant aborts zwave js

My system crashed and I installed the latest version. I used to run zwave and now it is deprecated. Tried installing zwave js and it worked, sort of. I could not add nor delete devices. Switched back to zwave and it did not accept where my controller is located. Switched back to zwave js and entered in the incorrect location of my zwave controller.

Now, when I go to supervisor hardware, there are sooooo many entries I could not find where my zwave controller was located. I made an error, somewhere in typing in the location. Now, I cannot even start zwave js. I am lost…

I had the same thing happen to me recently. Try powering down the device you have HA installed on and then after powering it back on, try re-adding the Z-Wave JS intergration.

But before you do that, try to identify the port your Z-Wave controller is on.

Thank you! I will try that.

That worked, thanks again.

I am glad that worked for you, Jim.