Home Assistant ZBT-1

Hardware
1

I have an original Home Assistant SkyConnect perfectly on my system for Zigbee. I recently purchased a new Home Assistant ZBT-1 to test out Z2M. I got it all up and running just fine, but have decided to stick with ZHA. I wanted to repurpose the ZBT-1 for Thread/Matter.

Here is where my problem comes in. When I go to System/Hardware, I have a red banner across the top with an exclamation point. However, there are no details provided.

image
image1869×239 8.26 KB

If I go into “All Hardware”, I can see the two dongles in USB0 and USB1 and they are both recognized correctly, but I cannot configure the ZBT-1 for thread. I did find this thread and followed the instructions. It has made no difference.

The system is running HAOS on a mid-2011 Mac Mini with the following versions.
image

Any help would be greatly appreciated. Thanks in advance.

2

See this: Home Assistant Connect ZBT-1 issue and replacement - Home Assistant

3

Thank you. I had seen that, but I don’t think that is my issue. Mostly because it is still visible in the “All Hardware” area. Although I noticed something weird. After following the info in the post I linked, it is showing up as Nabu Casu -C instead of ZBT-1.

4

Well. I finally got the ZBT-1 reprogrammed and initialized and recommissioned as a thread border router. Unfortunately, it has completely hosed my SkyConnect that I was using as my zigbee coordinator. So now I am looking at that. Still showing the red exclamation at the top of my hardware page.