How to replace Conbee 2 Zigbee stick and retain current config?

Configuration
7

Hi there,

I did not have to re-pair anything. I actually have now two NUCs with Conbees and I can remotely swap from different location to backup systems RPI3B+ with Raspbees. This was my procedure:

  1. I created a backup in Phoscon in existing system
  2. Shut down the host
  3. Pulled Raspbee out
  4. Installed Conbee
  5. Power on
  6. Changed the device address in deconz addon (device: /dev/ttyUSB0)
  7. Loaded the backup in Phoscon
  8. In hidden config loaded the last network configuration
  9. Rebooted the host

I think at some point I had to manually change in Phoscon the zigbee channel to 25 (from 20 which the new Conbee had) …

1 Like