Invalid config comfoconnect

Hi all,

I’m trying to put in place my zehnder in home assistant, but i receive this message.

Invalid config
The following component and platform could not be setup
comfoconnect
sensor.comfoconnect

my config seems to be ok, (i’ve made like the doc, and have no error in the logs)
the internal ip of the comfoconnect lan c is the good one (fixed ip)
the sensor are also good i think

is there something special more than whats is explained here to do ?

Ok, found in the log that the pin code is incorrect,

Are you sure that default pin code is 0000 ?

did’nt remember that i have encoded a pin code when installing the comfoconnect lan c ?
is the pin code linked to the comfoconnect lan C ? or linked to the Zehnder Air Q himself ?

it’s ok now.

i’ve made a factory reset.
i suppose i’ve put a pin code at install but really i don’t remember.

si factory reset to get the 0000 and put a new pin code.