Legrand Shutter switch up/down inverted with ZHA

Configuration Zigbee
4

I found a configuration error. All the switches are mounted upside down except for the one that works correctly. I managed to flip two of them over and connect the cables as per the instructions. I had to remove the devices from Home Assistant and add them again. Yay! Now, two switches are not reversed, I’ll have to fix all the others. I think the electrician didn’t do a very good job mounting them upside down.

In the two I fixed, the opening percentage still doesn’t work, but in the first one I configured, the partial opening works correctly. I can’t figure out why.

  1. When it’s not calibrated correctly, it stays in this state, with the green LED flashing.

    1. No comment!
    1. for dummies…

  4. Not work, needs a reset

  5. reset button

  6. Ready for pair

procedura
procedura1044×1009 99.3 KB

This in interessanting BTicino K4027C/L4027C/N4027C/NT4027C control via MQTT | Zigbee2MQTT

I have found this comment Legrand - No stop button on Roller shutter - #33 by Lomar . As soon as I have some free time, I’ll try it out and let you know.