Linkind Keypad with ZHA

Configuration Zigbee
1

Hello, I have a keypad and used to sync it with my alarmo over z2m.
I move all my installation on zha.
I see that now, my keypad is understending as an alarmpanel but if I arm it using a code, I can’t disarm it after.
Is there a way to configure a code ?
The keypad infos :

image
image1028×596 44.2 KB

I can activate it using keypad, or via HA, but no way to disarm it :
image
image614×730 25.8 KB

And after 3 atempt, the alarm is fired.
Any idea ?

2

Might be a bit late. But if you go into ZHA → Configure, when you have an Alarmpanel linked it will show the option to set an arm code there.

Alarmo and this Alarm panel are not linked though, so you need an automation for that to be able to link it.