hey!
thanks for creating this!
i had a couple of questions please. for my dishwasher specifically.
-
Is it possible to create a new “total run time” sensor please? So you know overall, when it started, when it ends, how long its been running but also the total time it will have taken (this way you can then work out how close to the end you are of overall cycle in a nice card!)
-
also not sure if just me, however the “elapsed” and “start” sensors dont seem to work and never seem to change?
-
it seems for me, that every time a new stage of the cycle starts, the values for the attribute “finishTime” and “Kickoff” reset back to 0, for that phase? is this by design? personally, it would be good if these didn’t change and were set for the whole cycle, not reset for each cycle phase
-
Anyway to add AutoDos levels to the sensor somehow?
-
All the time based values, dont see to be a “real” time, they are only “HH:MM” is it possible to use “real time” formats please?
