No GUI after fresh install of HAOS 10.1 on Odroid M1

Installation Home Assistant OS
1

Hi, I tried installing HA OS 10.1 on my new Odroid M1 using the following tutorial

First I updated the firmware using a micro-SD card, which went fine. Then I flashed HA OS on the SD-card. When I boot the machine connected to a display, after a while I see ‘Waiting for Supervisor to startup…’ followed by ‘Error returned from Supervisor: System is not ready with state: setup’. I retried this twice, with a reflash of the SD card in between.

Loading homeassistant.local:8123 in my browser doesn’t show any page. When I look in the DCHP log of my router, I see a message that leads me to think 192.168.0.222 got reserved for it. However, also that IP:8123 doesn’t show anything.

What should I do now?

2

I also tried this with the 10.0 image for the M1, same result.

3

Now it works. What I suspect (just guessing) is that there was a conflict with my existing HA installation on another device. Even though I had shut down (temporarily) that machine on purpose, perhaps the M1 nevertheless couldn’t claim the homeassistant hostname on the local network.

After I renamed my existing installation to another hostname, the (10.0) install on my M1 booted up very quickly and became available on homeassistant.local:8123