Hello
I am new here.
About using NodeMCU ESP8266 with Tasmota firmware.
I am try to do make a device to control my gates, front of my house like CLP by instance.
My project is:
IN1 – binary sensor to check the gates with reed swich
IN2 – binary sensor to check the gates with reed swich
IN3 – binary sensor to check the gates with reed swich
OUT1 -Relay to trigger gate 1
OUT2 - Relay to trigger gate 2
My doubt: when I configure on Tasmota GENERIC, the IN is associated to OUT. Don’t need this association.