Open Zwave control panel not working correctly

Configuration Z-Wave
1

I decided to switch over and use the All-in-one Installer. When I did this, I went to use the open zwave control panel, I was able to get to it fine, but I’m not getting a log when I use initialize and I’m not able to change the configuration from the control panel.

Any thoughts?

I’ve already changed the config link in the control panel to make sure it was pointing to the correct location.

2

Figured it out, wasn’t running it as root. :expressionless:

3

how to do this?

4

See this link: https://home-assistant.io/docs/installation/raspberry-pi-all-in-one/#using-the-ozwcp-web-application

5

thanks it works, at least I am in config mode.

What I like to know is the signal level of a zwave power plug connected to the network of the stick. How to check it inside open zwave panel (or other way)?