My first attempt of customizing Lanbon switch panel and two WT32-SC01 Plus with openhasp.
4 pages.
First page is quick setting scenes and quick look at indoor outdoor temperatures and what pellet stove pellets level , heat settings and cooler is set at.
Heating boost and antiboost
Page jasonl layout code
I will post changed and improvements on my gethub. Gethub repo
Added a human presence detector
HI-LINK LD2410 to end of hall SC01 plus.
It’s close to my HA so HA intergration with blue tooth works fine. Just used the cable with connectors that came with the SC01 plus and grabbed power from the plate.
So now I have automation to turn on screen when motion is less than 2 feet from it for over 1 second.
And shut off screen when the sensor has no occupancy detected.
As a test I also have aniburn run if no occupancy in the room for 60 min at night.
How did you manage to flash the wt32-sc01 plus? I’ve tried the 0.6.3 firmware but gets stuck in a boot loop and screen is blank. The online uploaded doesn’t support the esp32-s3. Read somewhere that it’s not supported and you have to use 0.7.3/4?
Was really excited when it turned up and now I’m on abit of a downer as I can’t seem to get it flashed!
Love your mount designs. I’ve designed my own to fit over a uk switch plate. I’ll share once I get it all up and running.