Problems with connecting Fibaro roller shutter 2

Configuration Z-Wave
1

Hi,

I’m trying to connect the ‘Fibaro roller shutter 2’ controller to my hassio (v 0.76.2).
I did everything by the Fibaro and HA manuals but still, I’m unable to connect it… I’m pressing ‘Add node’, I get:

2018-09-07 00:35:23.052 Detail, Queuing (Controller) Add Device
2018-09-07 00:35:23.053 Info, Add Device
2018-09-07 00:35:23.053 Detail, contrlr, Queuing (Command) ControllerCommand_AddDevice: 0x01, 0x05, 0x00, 0x4a, 0xc1, 0x0a, 0x7b
2018-09-07 00:35:23.053 Detail, Notification: ControllerCommand - Starting
2018-09-07 00:35:23.055 Detail,
2018-09-07 00:35:23.055 Info, contrlr, Sending (Command) message (Callback ID=0x0a, Expected Reply=0x4a) - ControllerCommand_AddDevice: 0x01, 0x05, 0x00, 0x4a, 0xc1, 0x0a, 0x7b
2018-09-07 00:35:23.059 Detail, contrlr, Received: 0x01, 0x07, 0x00, 0x4a, 0x0a, 0x01, 0x00, 0x00, 0xb9
2018-09-07 00:35:23.059 Detail,
2018-09-07 00:35:23.059 Info, contrlr, FUNC_ID_ZW_ADD_NODE_TO_NETWORK:
2018-09-07 00:35:23.059 Info, contrlr, ADD_NODE_STATUS_LEARN_READY
2018-09-07 00:35:23.059 Detail, Node001, Expected callbackId was received
2018-09-07 00:35:23.059 Detail, Node001, Expected reply was received
2018-09-07 00:35:23.059 Detail, Node001, Message transaction complete
2018-09-07 00:35:23.059 Detail,
2018-09-07 00:35:23.059 Detail, contrlr, Removing current message
2018-09-07 00:35:23.060 Detail, Notification: ControllerCommand - Waiting
2018-09-07 00:35:23.061 Info, WriteNextMsg Controller nothing to do

And that’s it. nothing happens…

I’m starting to think there is something wrong with the controller… I tried to pair it by pressing on the z-stick but it didn’t do anything as well…

Any ideas?

Thanks,
Max

2

I had the exact same issue and found that by re-setting the relay (disconnect from power, re-connect to power, press the b button until you get the led showing yellow, relase the b button and re-press until the light goes out).

Once the relay has been re-set, press the ‘add secure node’ button to start the connection process and then press the b button three times. That process worked for me. Good luck