Qubino dimmer for fan control: how to pre define fixed steps

Configuration Z-Wave
1

In my house im having a Vallox ventilation system. To make it more „smart“, I installed a z-wave based dimmer made by Qubino. It allows me to control the ventilation fan by setting an output voltage between 0-10V. This works pretty neat and I can set the level without steps using HA.

So here are my questions:
As for now, the dimmer is recognized by HA as a light entity and the level can be set using the brightness slider. Is there a way to somehow change that naming on the system level so that its not called light.something and brightness?

Second, and a more important question: Can I also have somehow 3-4 predefined settings (0, 85, 170, 255), so that i only need to click on a button to get the 4 steps mode?

Thx in advance

2

Hi,
I also connected Quibino dimmer, but I can up the speed only to speed 3 with steps. Any thought?

3

hello @rotbarsch,
I also have a Qubino 1 - 10V device. it is connected to my Fibaro HC2 hub which is connected to HA.
Mu qubino device presents itself as a switch.
how did you configure the devece as a light (dimmable)?

4

Hi, did you find a solution ? I have the same « problem ».

If yes can you share your solution ?

Best regards