Hi,
I’ve got a issue with two of mine z-wave devices from fibaro.
I asked this to fibaro:
Dear, I have 2 fibaro roller switches from you.
I am very satisfied with this. However, with my fibaro dimmers, all values are updated in real time.
With the roller switches, the status of the switch is not always updated and the level is not always updated. Even not after a while.
Can I set this up somewhere? This would be very desirable for my automation.
I’ ve got this answer back:
It is possible that it is a matter of sending the confirmation frame with the state setting. You should check whether the devices are within the good range from the Home Center. You can also reconfigure the mesh for these devices. Configuration/Settings -> Z-Wave -> Z-wave mesh reconfiguration -> choose malfunctioning device.
But how can I try this one home assistant?
Hopefully does anyone know this.
Thank you all.
Tom