Rf bridge and portisch firmware stops working after 3 hours

i have a rf-bridge with latest tasmota and latest portisch firmware.
some of my devices will only show up on rfraw 177, 166 doesn’t get me any code with these devices.
the problem is after a few hours it stops working all together.
if i do rfraw 177 in the console it starts working again.
anybody know of a solution?

1 Like

Same here. I have a nodered to listen to specific codes and only works if in 177 mode. Shouldn’t it be listening all the time? This was the whole idea of my project.

Create a rule that periodically sends a rfraw 177.