RF codes not working with RM4PRO and HA

Third party integrations
1

Hi,

I have an RM4PROD device and some RF rollers.
After reading a lot of tutorials and forum posts, I was able to successfully add RM4PRO to my homeassistant setup and learn the RF codes.
When I try to use the codes, the RM4 led flashes, but nothing happens.
Mentioning that using the RM4 app, I can open and close the RF rollers.
Any ideas on what the issue might be?

Much appreciate any help, it’s driving me crazy.

Thanks!

2

How IR data gets sent and received can vary quite a bit. It could be that you’re not learning the full code. Perhaps check your data against a known database of codes, or just use the codes from that database, if you can find them.

3

I think he is talking about RF data. However,

without showing what the OP has put inside HA configs/scripts/automations there is little one can do to support. How does he …try to use the codes? :thinking:

1 Like
4

My bad. I misread.

5

Hi! Thanks for taking time to reply!
I am simply trying to use the remote.send_command to trigger the rollers to go up or down:

service: remote.send_command
data:
device: tara_room_rollers
command: down
target:
entity_id: remote.broadlink_rm4pro_remote
device_id: 149c1580e2f11052d5ca4900e76578ad

6

Take a look at this post, maybe it helps.