Itâs probably me and my settings, and unfortunately I have to ask questions now.
Version 5.9.
I have the lights first half of the blueprint working fine for P1 Aqara Sensor detects motion, turn on light 100%.
Time mode, 6 PM to 9 PM. Adjusted to test.
Green entity bedroom bulb.
Works every night.
Trigger is Aqara P1 motion sensor.
That worked and still works if I change the times to test and turn off/disable night lights.
I also had nightlight working for one night.
That has stopped working.
Also time based. 9 PM to 6 AM
Green entity, same bedroom bulb.
Even if time is changed to now time and tested.
Iâbe used do not disturb as a night light entity state.
I think I used the same motion sensor as the toggle on night lights seemed to work for one night. So many changes and tests I donât remember. Lol
Rearranging the times and toggling DND to test night. Nothing.
P1 is always detecting motion and occupancy, not using occupancy, only motion. They both clear also.
Iâve tried DND as the night toggle, battery charging, the same motion sensor etc. If I manually run the automation, you can see the bulb is at 20 percent, times out, goes out, but wont fire again if time is adjusted and savedâŚ
I am getting an error occasionally which Iâm too newb to ID. And may or may not even be associated. But only a couple of times. No clue.
My apologies, Iâm a newb to HA anything, but learning fast.